Remington 476 Instrukcja Użytkownika

REMINGTON®POWERHAMMERModel 476OperatingInstructionsThe Remington Powerhammer is de-signed for use with Remington Powder 22caliber, Type A crimped load

10OPERATING THE TOOL1. ALWAYS hold tool perpendicular towork surface.2. Should the tool fail to fire, hold themuzzle firmly against the work sur-face

11GASLINEGASOLINE482-49POWDERLOADS482-51POWDERLOADSSafety Precautions90°30WATERSpallShieldG 018G 018G 018G 018G 018

126. Fasteners are a permanently in-stalled fixture. An act of demolitionis required for their removal. Appro-priate safety precautions must betaken.S

13POWDERLOADS482-54POWDERLOADS482-55YELLOW?BROWN ?GREEN ?GRAY ?NOTE: Failure to start with the lowest power level canresult in overdrive condition and

14Safety Precautions7. NEVER use fasteners longer than63.5mm (2 1/2”). NEVER use com-mon nails. Remington Power Fas-teners are manufactured from spe-c

15Safety PrecautionsOverdriven FastenersAn overdriven fastener results when toostrong of a powder load is used causingthe piston to extend past the mu

16LOADING THE POWERHAMMER1. Insert the proper fastener into themuzzle, round metal head first.Push fastener until the point is evenwith the end of the

17OperationSpringMust BeCompressedFiringPinLine UpGroovesMuzzleFiringPinGripBarrelChamberLOADINGFIRINGEJECTINGContinued

18CARE OF YOUR POWERHAMMERClean your Powerhammer after eachday’s use. Clean chamber with acces-sory wire brush, part number 56485.Apply good quality p

19Limited WarrantyDESA International warrants this RemingtonModel 476 POWERHAMMER against defects inmaterials and workmanship for a period of 30days f

2WARNING:Safety PrecautionsBEFORE USING1. ALWAYS handle the tool as if itwere loaded. Before starting work,check that the tool is unloaded andthe muz

101915-01Rev. B8/96IMPORTANTThis tool is designed to useRemington 22 caliber neck-downcrimped loads, power levels 1(gray) through 4 (yellow).Straight

3Safety PrecautionsDEFECTIVEWARNINGPOWDERACTUATEDTOOLSIN USE!G 018G 018

4Safety PrecautionsHANDLING THE TOOL1. NEVER place your hand over themuzzle. Accidental discharge cancause serious injury.2. ALWAYS store UNLOADED pow

5Safety PrecautionsPOWDERLOADSPOWDLOADG 018G 018G 018G 018G 018

63. NEVER make fastenings in spalledor cracked areas.Safety PrecautionsKNOW YOUR FASTENING BASEMATERIAL1. ALWAYS know the thickness andtype of base ma

7Safety Precautions????CENTERPUNCH TESTSinks inwithaveragehammerblowTOO SOFTTOO HARDPointflattensSurfaceshattersStart3GREEN2BROWN4YELLOWCASTIRONGLASST

8Safety Precautions4. NEVER drive fasteners into thin oreasily penetrated materials unlessit is backed by concrete or steel.When in doubt, such as whe

9Safety Precautions1”TOO THINWELD1/2”NOYESG 018G 018G 018G 01876 mm3"3X1X76mm3"76mm3"76mm3"5 mm MIN3/16" 25 mm1"13 mm1/